TR Declaration is a conformity assessment statement that the products put on the market comply with national technical regulations and standards of the Russian Federation. This statement is mandatory for product export to Russia and placing on the market.

The fedral law of the Russian Federation about technical regulation set two forms of conformity assessment: TR Declaration und TR Certification.

TR Declaration and TR Certificate have the same legal force and are valid on the whole territory of Russia.

TR Declaration is on the contrary to the TR Certificate a simplified form of the conformity assessment and can be substituted by the TR Certification. TR Certificate cannot be replaced by the TR Declaration.

By TR Certification both the applicant (manufacturer, importer or an authorized representative) and the notified body in Russia bear the risks. by TR Declaration only the applicant is responsible for safety of the products and its compliance with the standards.

Legal framework

With the aim to replace the old GOST system, law № 184 "About technical regulation" was adopted 2003. 18 technical regulation (TR) of the Russian Federation came into force.

Nontheless the TR system did not have large dispersion because 2011 new technical regulations of the Customs Union, later Eurasian Economic Union (TR ZU and TR EAEU) were elaborated. TR CU and TR EAEU have replaced the old TR regulation successively.

Legal framework of the TR Declaration:

The products listed in the Annex to Governmental order № 982 are subject to TR Declaration. For these products listed in the Annex TR Declaration is obligatory. Without TR Declaration it is impossible to import goods to Russia.

Only a company established in the territory of the customs union may apply for TR conformity assessment statement.
Schmidt & Schmidt has a branch office in Russia and thus has the right to act as an authorized representative in conformity confirmation for companies from abroad,

Reform of the technical regulation within the scope of the Eurasian Economic Union

EAC Certifikate, EAC Certification, EAC Declaration, EAC Declaration

As a consequence of the coordination of national safety standards between Russia, Belarus and Kazakhstan, the previous national Technical Regulations such as Russian GOST and TR certification were gradually phased out and substituted by the new Technical Regulations of the EAEU (TR EAEU) in every industrial sector. In addition to the EAC certification, the EAC declarartion has also been introduced in the Customs Union as a simpler and less expensive form of proof of conformity.

The new system was modelled on the european CE marking and many Technical Regulations are coordinated with EU guidelines. One can say that the Technical Regulations of the Customs Union correspond to the EU guidelines.

Application area

TR conformity assessment procedure

A TR Declaration is issued upon application by the notified body.

There are 5 schemes of the conformity assessment depending on whether it is a serial production or a single delivery.

The conformity assessment can be carried out either on the basis of own or external tests.

If the test are carried out by the manufacturer, test reports must be written.

External test must be carried out at any from Rosstandart accredited laboratory.

After the issuance of the TR Declaration it must be enrolled by the Register. After it the Declaration gets its identification number.

The TR Declaration has no binding form and can be issued on the DIN A4 paper.

There is no voluntary TR Declaration. If desired, it is possible to apply for a voluntary GOST Certificate.

A TR Declaration is valid for 5 years.

Documents required

Each Technical Regulation has different requirements for the corresponding documentation. Typically these are:

TR Declaration contains following information:

  • address and Name of the manufacturer
  • list of the declared products
  • norms and standards of the technical regulation applied
  • information about test
  • validity
  • registration number
  • name of the notified body

Conformity assessment marking

TR Conformity assessment Marking

The products certified according to the Technical Regulations of the Russian Federation, for which a TR certificate has been issued, must bear the TR mark in order to demonstrate conformity with all legal requirements of the Russian Federation.

Length and costs for TR certification

The length and costs associated with a certificate application, depend on several different factors, such as the classification of product, any required laboratory checks and complexity of all examinations. As such the exact conditions of the certification are always determined individually based on the required documentation.

Delivery of the documentation

If you order a TR certificate, you will receive a copy of it via email immediately upon our successful certification process. The original document will be delivered a few days later.

Duration and costs for TR Declaration

The duration and costs associated with an TR declaration application depend on several different factors, such as the classification of the product, any required laboratory checks and the complexity of all examinations. As such the exact conditions of the EAC certification are always determined individually based on the required documentation.
Please note that an application for a TR edclaration can take up to 7 days.

Please feel free to call us or send us an email. We will provide you with a free, non-binding quote and will be glad to answer all your questions about TR declaration. Let us convince you of the quality of our services!

In our video, we explain what an EAC Certification is and how and where to certify or declare your products for the introduction on the EAEU market.

The EAC Certification and the EAC Declaration are complex procedures that attest your products the conformity with the technical regulations of the EAEU and require a lot of know-how. Schmidt & Schmidt will support you with the certification of your products for the EAEU market.

SEPA Bank Transfer

Qualified team of experts and consultants

Our experts have many years of experience in export and certification

Certification of all product types

We work with clients from all branches of industry

Quick processing of orders

We handle client's needs individually and process the requests quickly

Profound knowledge of technical regulations

Due to our technical and legal know-how, we guarantee high quality of services

Free delivery of documents

Your documents will be provided free of charge in the shortest possible time